Last month, I built NewsAlarm – a modified smoke alarm wired into the NYTimes NewsWire API. It can be configured to sound in response to any keyword or keywords coming over the wire at a specific frequency; for example, you might set it to alarm when 50% of the headlines coming in contain the words ’space aliens’ or if 10% of the headlines include the word ‘evil robots’. It’s a pretty ridiculous device, meant to embody the equally ridiculous alarmism (pun intended) that permeates mainstream media.
The orginal NewsAlarm was hard-wired to the computer via an Arduino. It worked quite well, but it’s not very convenient – it can only get as far away from the computer as the wires allow, which is only about 5 feet. I wanted the device to be able to be a long way away from the computer processing the NewsWire data, and I also wanted one computer to be able to trigger multiple NewsAlarms. So, I looked into ways that I could connect the devices and the computers wirelessly.
The solution turned out to be the XBee – a cute little device that allows signals to be sent via 802.15.4 wireless. XBees are small, cheap, and can be combined to create simple mesh networks. Perfect! For the wireless NewsAlarm, 2 Xbees act as a transmitter and a receiver. A very simple serial signal is transferred from one XBee to the other when the alarm is triggered. Our system uses two arduinos right now, though it could be re-configured to use one and an FTDI cable.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: CircuitPython 2025 Wraps, Focus on Using Python, Open Source and More! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey
?!