Finally, I have succeeding in producing my own variation on the MintyBoost. I found inspiration on this post (http://forums.adafruit.com/viewtopic.php?f=15&t=18225) on the Adafruit forums. It looks like a stick of gum, and I like it, because it’s single-sided, and because it looked like it would be pretty easy to make at home with my toner transfer setup. I call it the MintStick, because sometimes I don’t like to spend a lot of time trying to come up with good names for things. It’s version 3.0 to indicate compatibility with the MintyBoost 3.0 (since it ought to support the same devices).
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.