BACK IN STOCK – Stepper motor – 200 steps/rev, 12V 350mA! A stepper motor to satisfy all your robotics needs! This 4-wire bipolar stepper has 1.8° per step for smooth motion and a nice holding torque. The motor was specified to have a max current of 350mA so that it could be driven easily with an Adafruit motor shield for Arduino (or other motor driver) and a wall adapter or lead-acid battery.
Some nice details include a ready-to-go cable and a machined drive shaft (so you can easily attach stuff). We drove it with an Adafruit motor shield for Arduino and it hummed along nicely at 250 RPM.
- 200 steps per revolution, 1.8 degrees
- Bipolar stepper, requires an H-bridge!
- 4-wire, 12 inch leads
- 42mm/1.65″ square body
- 31mm/1.22″ square mounting holes, 3mm metric screws (M3)
- 5mm diameter drive shaft, 24mm long, with a machined flat
- 12V rated voltage (you can drive it at a lower voltage, but the torque will drop) at 350mA max current
- 28 oz*in, 20 N*cm, 2 Kg*cm holding torque per phase
- 35 ohms per winding
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — The Prepared Podcast – Jonathan Cedar, BioLite
Wearables — Start with a sketch
Electronics — My signal isn’t THAT noisy, is it?
Biohacking — Fine Tuning Fluorescent Dyes
No comments yet.
Sorry, the comment form is closed at this time.