0

May 20, 2011 AT 4:19 pm

Good Circuit Boards Require Good Clamping

5696781021 22798E8Ac2 Z

Good Circuit Boards Require Good Clamping… Mikey writes –

I produced a great looking board yesterday on my little CNC mill. The solution was to add $4 worth of fender washers so that I could remove any vibration from the mill table. I’m using the same bits and configuration files between the these two circuit boards. The only thing that changed was the fender washers.

Good tips!

Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!

Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!

Maker Business — Alibaba to invest $15b in tech, set up research labs around the world

Wearables — Hand beading mimicry

Electronics — Trigger happy oscilloscope?

Biohacking — Biohacking: Visioneer – AI Glasses to Assist the Visually Impaired

Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at AdafruitDaily.com !

2 Comments

  1. johngineer
    May 20, 2011 at 4:56 pm

    Good fixturing is the difference between success and failure. Always.

  2. george graves
    May 20, 2011 at 11:41 pm

    Be careful with that dust. Looks like some lung cancer waiting to happen. (Insert Debbie Downer joke here)

Sorry, the comment form is closed at this time.

Filed under: EE — by adafruit

Comments (2)