I present to you, the RepRap tie!
For years people have made ties out of wood, and I adopted the principle for 3d printing. Could it be a world first?
The basic idea is to take a 3d model, cut holes in it for string and then cut it into smaller pieces so the tie will bend.
I’m not overly satisfied with how the ties sits around the neck, perhaps someone has an idea for a better solution?
Also, any special ideas for a tie, just make a comment and I’ll give it a go. 🙂
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Transforming Today’s Bad Jobs into Tomorrow’s Good Jobs
Wearables — Etching a stencil
Electronics — Is your op amp going crazy?
Biohacking — Token – A Wearable Ring with NFC & Bluetooth
No comments yet.
Sorry, the comment form is closed at this time.