February 1, 2012 AT 6:40 pm
NEW PRODUCT – Adafruit Proto-Plate for Beagle Bone
NEW PRODUCT – Adafruit Proto-Plate for Beagle Bone. Ready to prototype your next BeagleBone project? You’ll certainly want this handy Proto-Plate! Not only is it really good looking, its also very useful, holding your BeagleBone steady alongside a standard half-sized breadboard.
The plate is made of 3mm thick laser-cut clear acrylic with nice engraving showing alignment. There are four 4-40 screws, standoffs and hex-nuts to attach the ‘Bone on and the halfsized breadboard can be stuck on (just remove the paper backing from it). Finally, there are four rubber bumpers you can use to lift the plate off of your table, so it won’t slide around.
BeagleBone and half-sized breadboard are not included! You can pick those items (as well as other BeagleBone toys in the shop
- 3″ x 4″ acrylic plate, laser cut
- 4 x 4-40 1/2″ screws
- 4 x 4-40 hexnuts
- 4 x 4 3/8″ nylon standoffs
- 4 x rubber bumpers
Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Shenzhen: The Silicon Valley of Hardware (Full Documentary) and Who invests in hardware?
Wearables — Take flight with shiny wings
Electronics — Inadequate volt signal
Biohacking — The Upside of GMOs (Genetically Modified Organisms)
1 Comment
Sorry, the comment form is closed at this time.
Beautiful. Is it possible to get a cape for this?