NEW PRODUCT – Arduino Ethernet shield R3 with micro SD connector – Assembled. The Arduino Ethernet Shield R3 (assembled) allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip (datasheet). The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield.
The new Ethernet shield now includes a micro SD card connector, it is MEGA compatible and an on-board reset controller.
The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.
Arduino uses digital pins 10, 11, 12, and 13 (SPI) to communicate with the W5100 on the ethernet shield. These pins cannot be used for general i/o.
The shield provides a standard RJ45 ethernet jack. An Arduino is necessary to use this shield but is not included.
- Dimensions: 73mm x 54mm x 17mm (2.8in x 2.1in x 0.7in)
- Weight: 26g / 1oz
For more information, check out the Ethernet shield page and Getting started guide. We have a tutorial on how to use this shield as a file webserver!
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Transforming Today’s Bad Jobs into Tomorrow’s Good Jobs
Wearables — Snap a picture
Electronics — To Y5V or not to Y5V?
Biohacking — Quantified Bob’s Experience with Ketone Esters
No comments yet.
Sorry, the comment form is closed at this time.