This laser cut Raspberry Pi enclosure design features light pipes for the status LEDs and obscures the T-slots for a nice clean looking enclosure.
All off board connectors are accessible with the top off and you can use standard ribbon cable connectors through the case to hook up the expansion header as well. Spacing of the top layers have been adjusted so these should be compatible with pi plates when they become available with minimal additional hardware.
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — “Analog Devices to Buy Linear Technology for $14.8 Billion”
Wearables — Practice patience
Electronics — Look to ferrites (no, not ferrets, the European polecat) when faced with high frequency
Biohacking — TCAPS and Mary Roach on The 99% Invisible Podcast
No comments yet.
Sorry, the comment form is closed at this time.