We hacked a motorized fader found in audio mixing consoles to create the force feedback. If you are interested, you can read the paper. Basically, the way we achieved this is by drawing a force curve and storing the values in a table, then we send the current position of the slider through the table and extract the value to send to the motor that applies an opposing force. You can check this in action in the “How it Works” part of the video.
We programmed in Max/MSP and Arduino. For controlling the hardware, we used an Arduino-based microcontroller called Music & Motors… developed by CIID.
This project was made by Hideaki Matsui and I (Andrew Spitz) in a class on Haptics at CIID run by Bill Verplank and David Gauthier.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7pm ET! To join, head over to YouTube and check out the show’s live chat – we’ll post the link there.