Following discussions about the Open Source and Open Source Hardware logos, the Open Source Initiative (OSI) and the Open Source Hardware Association (OSHWA) have worked together to compose a co-existence agreement on behalf of their representative communities.
We are pleased to announce that the co-existence agreement has now been approved and signed by both organizations. This agreement means that each group separately has control of their respective logo and in particular that the Open Source Hardware community will be able to continue to use the Open Source Hardware logo.
As per the agreement, OSHWA will (in the near future) publish guidelines for the use of the OSHW logo, designed to promote its use in compliance with the Open Source Hardware Definition. Until then, if you are using the OSWH logo, please make sure that you are following the OSHW definition. And, to use the OSI logo, please refer to OSI’s trademark usage guidelines.
View the OSI OSHWA Agreement.
So, anyone putting the OSHW logo on your boards, you’ve always been fine, you are fine and you always will be fine
This is the outcome we asked as OSHW makers for from the start and it’s great to see this happening and official two open source orgs working together for the benefit of all. For the folks following this story, last year Phil ask the previous OSI board if the gear logo was ok after there were questions if it was too close to the OSI logo (Phil contacted the previous OSI members and they said it was fine) but this year with a new OSI board this process re-started. In a fun twist, the OSI logo appears to be Phil’s logo he debuted at OSCON about 10 years ago. Below…
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Sorry, the comment form is closed at this time.