Awesome resource for creating enclosures and cases for your Pi from the Raspberry Pi Spy. I’m definitely going to make use of this for my 3D-printed Raspberry Pi enclosures!
One of the improvements made to the Revision 2 board was the addition of two mounting holes. These give hobbyists some extra options when it comes to mounting the Pi. There are only two holes so care is still required to avoid putting the PCB under unnecessary stress but some holes is better than none.
The holes are 2.9mm and have been designed to accept 2.5mm (M2.5) screws or bolts. My local DIY store didn’t sell bolts this small so I ordered some off the internet….
Each Friday is PiDay here at Adafruit, be sure to check out our posts, tutorials and new Raspberry Pi related products. Have you tried the new “Adafruit Raspberry Pi Educational Linux Distro” ? It’s our tweaked distribution for teaching electronics using the Raspberry Pi. But wait, there’s more! Try our new Raspberry Pi WebIDE! The easiest way to learn programming on a Raspberry Pi.
Want a FREE RASPBERRY PI? All orders over $350 get a FREE Raspberry Pi Model B with 512MB RAM!
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Alibaba to invest $15b in tech, set up research labs around the world
Wearables — Hand beading mimicry
Electronics — Trigger happy oscilloscope?
Biohacking — Biohacking: Visioneer – AI Glasses to Assist the Visually Impaired
No comments yet.
Sorry, the comment form is closed at this time.