Here’s a handy workaround that a Pi community member came up with so that he could use his low-profile Micro SD adaptor in his favorite case – the Rainbow Pibow with the nylon bolts tightened down. Via RaspberryPi.org Forums.
I devised a workaround for the extra width that the Micro SD adaptor requires. I used the fibre rings that you get with a new motherboards, these things:
One ring was put on each corner screw, between the purple and transparent lower layer.
The rings add just the right amount of extra for the Micro SD card holder. I’m very happy with this workaround – the extra width between the layers is not noticeable in normal use.
Each Friday is PiDay here at Adafruit, be sure to check out our posts, tutorials and new Raspberry Pi related products. Have you tried the new “Adafruit Raspberry Pi Educational Linux Distro” ? It’s our tweaked distribution for teaching electronics using the Raspberry Pi. But wait, there’s more! Try our new Raspberry Pi WebIDE! The easiest way to learn programming on a Raspberry Pi.
Want a FREE RASPBERRY PI? All orders over $350 get a FREE Raspberry Pi Model B with 512MB RAM!
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Transforming Today’s Bad Jobs into Tomorrow’s Good Jobs
Wearables — Hot glue free zone
Electronics — Have you met Charlie?
Biohacking — Ticks are Spreading an Allergy to Meat
No comments yet.
Sorry, the comment form is closed at this time.