This is a protective case for the NTSC LCD screen listed here on Adafruit.
It is designed like the PiBow in layers.
The parts are pretty delicate when you cut them but when put together it is a lot stronger than the LCD panel by itself.
Use 1/16 “ acrylic.
I split cutting into 3 layers to allow cooling and to keep all holes in place until outside cut is made.
Parts 4 and 5 require you to fit the controller board through the slot.
4 Small holes on outside edge are for 3/4” x 2-56 screws.
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Shenzhen: The Silicon Valley of Hardware (Full Documentary) and Who invests in hardware?
Wearables — Take flight with shiny wings
Electronics — Inadequate volt signal
Biohacking — Movie: The Immortalists – Live Forever… or die trying.
No comments yet.
Sorry, the comment form is closed at this time.