Raspberry Leaf for Raspberry Pi and Breadboard #piday #raspberrypi @Raspberry_Pi
Here’s a handy tool for patching directly into the GPIO block of the Raspberry Pi, from Dr. Simon Monk!
I thought I would share this little helper I have made to simplify using the Pi with jumper wires.
If you are using your Raspberry Pi with Breadboard, and you have lots of connections to make, then the Pi Cobbler from Adafruit is pretty neat. However, sometimes you only need to make a couple of connections and the Cobbler is overkill and a few Male to Female jumper leads will do just fine.
The drawback with using Male to Female jumpers direct onto the GPIO is that you then have to count down the pins trying to find the pin you need, because nothing is labelled. Matching a diagram of the pinout to the actual pins is not easy and mistakes can be made.
Enter the Raspberry Leaf! Okay, so its just a bit of paper, with all the pin labels on. Just save it, print it out, and cut around the border. It’s saved at 300 dpi.
To fit it onto the GPIO pins, I found it easiest to make the holes first by placing it over some breadboard and pushing a header pin through each hole in turn.
Pushing it all the way down to the bottom of the GPIO connector needs tome help from a plastic tool – or if you turn off your Pi and, use a small screwdriver. DON’T DO THIS WITH THE Pi POWERED UP!!!
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: A New Arduino MicroPython Package Manager, How-Tos and Much More! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey