The amazing InMoov project is on the front cover of the next issue of The Atlantic Magazine. Too bad the article is about robots in general, and not about the InMoov project itself.
A few months ago I was asked by an American set designer, if I would let them use InMoov hand for to make the front cover of The Atlantic magazine.
Attribution is to be expected inside the magazine. Behing abroad, I have not the chance to buy it for to check it out.
Looking at the result, they did a good job on the finishing touch. If I remember correctly, it was printed in PLA with a 0.3mm thickness. They did a finishing coating with paint, but I would guess they had to use a primer with a good sending job.
Check out the InMoov project on Thingiverse, and print your own!
Join 6,000+ makers on Adafruit’s Discord channels and be part of the community! http://adafru.it/discord
CircuitPython in 2018 – Python on Microcontrollers is here!
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Follow Adafruit on Instagram for top secret new products, behinds the scenes and more https://www.instagram.com/adafruit/
Maker Business — Aquarium troubles: the cost of iteration and troubleshooting with a manufacturers abroad
Wearables — Plastic gem know-how
Electronics — Counting Pin Numbers
Biohacking — Exploring Our Inner Reality : Entopic Visions
Python for Microcontrollers — CircuitPython 3.0.0 Release Candidate 0 released!
Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at
AdafruitDaily.com !
No comments yet.
Sorry, the comment form is closed at this time.
