The ribbon is approximately 21″/53cm long, and has 10 white LEDs spaced equally along the ribbon. You can cut the ribbon easily but you cannot solder to it so once it’s cut, it cannot be re-joined. The battery pack has a simple controller that switches between a few modes: all on, fast blink, slow blink, and a slow fade in and out. It is powered by and comes with 2 x 12mm coin cell batteries, but you can also get some more from us. We also have extra battery packs. It is possible to cut the ribbon in half and then snap another battery pack onto the second piece.
Powered by 2 x CR1220 batteries
Dimensions: 15.43mm / 0.6″ x 30.47mm / 1.2″ x 10.54mm / 0.4″
NEW PRODUCT – Litex Spare Battery Case – This is a little battery pack for our Litex LED ribbons. No LEDs are included, but the battery pack is very nice and you can cut the LED ribbon in half and then use the extra battery pack to power the excess.
Comes with two CR1220 batteries, we also carry extras if you need them!
Dimensions: 15.43 / 0.6″ x 30.47mm / 1.2″ x 10.54mm / 0.4″
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7pm ET! To join, head over to YouTube and check out the show’s live chat – we’ll post the link there.