0

October 31, 2013 AT 12:22 pm

Raspberry Pi Halloween costume – Adafruit Trinket and Neopixel Ring (echo boo)

Rpi Halloween Jpl1-Talkingjay

Sadly my Halloween costume this year doesn’t use a Raspberry Pi but it is inspired by it with red and green colors and the RPI logo stenciled (with a Pibow case). It uses the Adafruit Neopixel Ring (http://www.adafruit.com/products/1463) and Trinket (http://www.adafruit.com/products/1501) with a usb cable down the back of my shirt to a basic portable phone charger. There are a few extra wires for effect as it only uses ground, 5v and pin 0 for data in.

More photos here!


Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!

Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground”Adafruit’s Apps!


Maker Business — Shenzhen: The Silicon Valley of Hardware (Full Documentary) and Who invests in hardware?

Wearables — Take flight with shiny wings

Electronics — Inadequate volt signal

Biohacking — Movie: The Immortalists – Live Forever… or die trying.

Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at AdafruitDaily.com !



No Comments

No comments yet.

Sorry, the comment form is closed at this time.