I just got my Tiny 3-Axis CNC to work with the Adafruit Trinket (courtesy of Hackaday!). While it doesn’t yet work with the Adafruit Fake Serial, that’s my next goal.
Join my drawing robot newsletter http://shor.tw/x6 to catch all the latest developments or check out my blog http://PlotterBot.com for detailed build instructions, wiring diagrams, and everything else you need to make one for yourself.
Trinket may be small, but do not be fooled by its size! It’s a tiny microcontroller board, built around the Atmel ATtiny85, a little chip with a lot of power. We wanted to design a microcontroller board that was small enough to fit into any project, and low cost enough to use without hesitation. Perfect for when you don’t want to give up your expensive dev-board and you aren’t willing to take apart the project you worked so hard to design. It’s our lowest-cost arduino-IDE programmable board!
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Shenzhen: The Silicon Valley of Hardware (Full Documentary) and Who invests in hardware?
Wearables — Take flight with shiny wings
Electronics — Inadequate volt signal
Biohacking — The Upside of GMOs (Genetically Modified Organisms)
Sorry, the comment form is closed at this time.