This version is about half the width of the original (50 mm), which means its 1/8 the volume and a much faster print (yay math!). i find it takes me ~2 hours to print one (and ~8 for the original)
Rather than just being a straight scaling, this version has been tweaked so taht it will still rotate. The main differences are the number of gear teeth (much fewer, and larger), gear ratio (it now takes 2 rotations to realign, unfortunately) and pins (made much beefier, and they are all one length).
Additionally, there is a hole through the tip so that it can serve as a keychain! Print them out by the dozen and give them to friends/family/cute girls on the bus!
Eink, E-paper, Think Ink – Collin shares six segments pondering the unusual low-power display technology that somehow still seems a bit sci-fi – http://adafruit.com/thinkink
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.