Playing Chiptunes with an Arduino Micro! #ArduinoD14
Verspira uses an arduino micro to play ‘Last Chip Standing’ by Chewrafa, from the arduino blog.
All audio generated on the Arduino. If you look closely, you will see that I added a yellow wire going from the TXLED to the empty hole that was drilled over by the reset button. I added a single pin though this hole and epoxied the plastic in place to give myself another bread-boardable pin that has access to the PD5 signal which was not broken out. Simple mod really.
The audio probably suffers a bit from my DAC since the resistors were 5% tolerance and I did my best to hand-match them down to 0.1%. I’m looking to get a real 8bit DAC and put it on this Arduino to see if there are any improvements.
All audio from the Arduino, with an LM386 amplifier on the receiving end of my R-2R DAC. Resistances were 10K and 20K (actual 9.85K and 19.70K).
March 29th is Arduino Day 2014! Arduino day is “a worldwide event bringing together Arduino people and projects. It’s 24 hours full of events – both official and independent, anywhere around the world – where people interested in Arduino can meet, share their experiences, and learn more.” Adafruit will be celebrating with 24 hours of Arduino posts on our blog as well as a special Saturday night LIVE show with Massimo Banzi, co-founder and CEO of Arduino. Join us Saturday, March 29th at 7 PM EST to celebrate Arduino Day 2014! Be sure to check out our extensive learning system tutorials on Arduino as well as our Arduino blog coverage and products.
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, or even use Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for MakeCode, CircuitPython, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.