0

September 1, 2014 AT 5:00 am

From the Forums: Trinket weather sensors, incorporating anemometer, wind vane, and rain gauge

Pasted Image 8 31 14 11 41 PM

Joe shared his project to create a grouping of Trinket weather sensors, incorporating anemometer, wind vane, and rain gauge on the Adafruit Forums!

I finally completed migrating the weather sensors for the weather station that is at my father-in-law’s farm. I had issues with the rain gauge not working too well with the pi directly, so I decided to use an Adafruit Trinket to capture the values of the sensors and send them to the pi for tracking. The communication between the two is accomplished using I2C.

Here’s the completed mast with sensors attached. (This is actually a pic of it at my house for testing) What you’ll need for this is 1 of each of an anemometer, wind vane & rain gauge. It works with the sensors I built, but I’m sure you could incorporate it to use any sensors you have as well….

Read more.

Pasted Image 8 31 14 11 45 PM

Pasted Image 8 31 14 11 45 PM


Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!

Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground”Adafruit’s Apps!


Maker Business — Transforming Today’s Bad Jobs into Tomorrow’s Good Jobs

Wearables — Make metallic magic

Electronics — Inadequate volt signal

Biohacking — Arduino Based “Row Bots” Test Rowing Efficiency

Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at AdafruitDaily.com !



No Comments

No comments yet.

Sorry, the comment form is closed at this time.