This instructable shows how to use a ‘Simple but Strong Plastic Box’, (http://www.instructables.com/id/A-Simple-but-Strong-Plastic-Box/) from my previous Instructable, to make a Two Faced Clock which uses a Raspberry Pi to control two stepper motors.
I’ll not explain how to make the box itself, but will show how to measure, mark and make the holes for the stepper motor drive shaft.
At the end will be links to github where my sample code can be found and down loaded.
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Undercover in an iPhone Factory (video)
Wearables — Go with silicone
Electronics — Shift away from basic arithmetic
Biohacking — Recording and Biohacking a 100 Mile Run
No comments yet.
Sorry, the comment form is closed at this time.