Woodworkers need to keep their tools sharp, and if you aren’t careful, it’s easy to chip them or cut yourself badly on a properly sharpened tool.
Edge guards are a great Maker project, but they can be difficult to construct with a snug enough fit on the tools. Many people have used plasti-dip for this purpose, but plasti-dip tends to be very unfriendly to work with, and can result in a fairly loose fit. Enter low-temperature thermoplastic.
Each Tuesday is EducationTuesday here at Adafruit! Be sure to check out our posts about educators and all things STEM. Adafruit supports our educators and loves to spread the good word about educational STEM innovations!
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.