In line with my other projects I need to make a USB hub attachment for the Pi Zero.
Seeing as the community figured out that the Raspberry Pi Design team was clever enough to leave us D+ and D- test points at the bottom, I came up with this design above.
See those pads for D+, D-, gnd and 5v? Yip, the ide is that you can acually reflow this board onto the back of a Pi Zero!
Where’s the Gerbers? I haven’t uploaded the gerbers to Github yet, since I only finished the Eagle drawing a few mins ago. Eagles are off to DirtyPCBs.com, and once I tested the board, I’ll upload.
This is a 4 Port USB2.0 hub designed around the TI TUSB2046B
Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.