0

March 29, 2016 AT 2:28 pm

Magic Lamp uses Trinket and NeoPixel Ring, Qi Wireless Charging

photo-41

neopixel-gif

The idea for this little project is to have a lamp which can be turned on or off simply by moving it on a desk.

A wireless charging base is built into the desk’s surface, and a circuit with microcontroller and LEDs gets powered wirelessly using the charging coil.

Full project build notes on Hackster.io.


Featured Adafruit Products!

NewImage

Adafruit Trinket – Mini Microcontroller – 5V Logic: Trinket may be small, but do not be fooled by its size! It’s a tiny microcontroller board, built around the Atmel ATtiny85, a little chip with a lot of power. We wanted to design a microcontroller board that was small enough to fit into any project, and low cost enough to use without hesitation. Perfect for when you don’t want to give up your expensive dev-board and you aren’t willing to take apart the project you worked so hard to design. It’s our lowest-cost arduino-IDE programmable board! Read more.


NewImage

NeoPixel Ring – 12 x 5050 RGB LED with Integrated Drivers: Round and round and round they go! 12 ultra bright smart LED NeoPixels are arranged in a circle with 1.5″ (37mm) outer diameter. The rings are ‘chainable’ – connect the output pin of one to the input pin of another. Use only one microcontroller pin to control as many as you can chain together! Each LED is addressable as the driver chip is inside the LED. Each one has ~18mA constant current drive so the color will be very consistent even if the voltage varies, and no external choke resistors are required making the design slim. Power the whole thing with 5VDC and you’re ready to rock. Read more.


Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!

Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground”Adafruit’s Apps!


Maker Business — Transforming Today’s Bad Jobs into Tomorrow’s Good Jobs

Wearables — Etching a stencil

Electronics — Is your op amp going crazy?

Biohacking — Token – A Wearable Ring with NFC & Bluetooth

Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at AdafruitDaily.com !



No Comments

No comments yet.

Sorry, the comment form is closed at this time.