This is the Housing for my Skateboard Speedometer. It´s fitting on independent trucks. This projekt is on Hackaday. Please have a look:
The housing is still under improvement. I will try a few way to fastened it on the truck. In the final version the lid will be screwed on. Also different housings needed for different truck companys.
I printed it in PETG, 0,2mm layer hight. Just a fast print because it´s only a prototype.
The Video was done before the printer was ready with the housing;)
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — The Prepared Podcast – Jonathan Cedar, BioLite
Wearables — Start with a sketch
Electronics — My signal isn’t THAT noisy, is it?
Biohacking — Fine Tuning Fluorescent Dyes
No comments yet.
Sorry, the comment form is closed at this time.