0

April 20, 2016 AT 7:00 am

sACN Artnet LED Driver #Arduino

From Bob Lynas on YouTube:

This project really packs some punch for a small AVR processor, I am using an Arduino Nano (32k/2k) and a piggy backed 10T ethernet board (ENC28J60), most of the flash and ram are used but it can still serve a half decent config browser page along with the ability to switch over to UDP streaming mode to convert data to either ArtNet or sACN (E1.31). Two independant Universes (512bytes each, 340 RGB pixels in total) are decoded and each universe is sent out via a 3 pin JST plug to a panel of WS2811/WS2812(b) Pixel LEDs. Comments & Questions appreciated

Read more


Check out all the Circuit Playground Episodes! Our new kid’s show and subscribe!

Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground”Adafruit’s Apps!


Maker Business — MakerBot’s technology of the future grapples with its rocky past

Wearables — Glue thoughts

Electronics — Check out this shorthand shortcut

Biohacking — Take a Tour of the Alcor Cryonics Facility

Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at AdafruitDaily.com !



No Comments

No comments yet.

Sorry, the comment form is closed at this time.