Then I created the two coils using 32mm PVC and 23 turns of 1mm2 multicore copper wire. I calculated the inductance to be 8.8uH, and a prototype coil proved to be in the ballpark of the calculated value.
Read about the results here at DIYcrap.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Maker Business — Transforming Today’s Bad Jobs into Tomorrow’s Good Jobs
Wearables — Snap a picture
Electronics — To Y5V or not to Y5V?
Biohacking — Ticks are Spreading an Allergy to Meat
No comments yet.
Sorry, the comment form is closed at this time.