3Rotor shared this print on Thingiverse
An 4 part stand that only needs the addition of 2 M8 Bolts/nuts and a little spring with some washers, Provision is made for a locking screw( M6) if it’s needed.
This stand is to Hold a circuit board while components are being soldered in, facilitating easy rotation to get access to both sides of the board for soldering.
rubber feet can be attached to the bottom, to give is more sturdiness in its stand.(not required)
This device complies with Einstein’s general simplicity principles, in that it is as simple as it possibly can be, but no simpler… :~)
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!