Here is my source of air or as the organ folks say, wind. I couldn’t afford a real organ blower so I went with the Shop-Vac solution. I built this box to accomplish two things. First, one could hardly hear the organ over the roar of the Shop-Vac so I needed to do something about the noise. Second, the higher the pressure in the organ the higher the pitch of the pipes. Therefore, a pressure regulator is needed to limit the changes in pressure that occur as different numbers of pipes are playing at one time. The lower box contains the Shop-Vac and muffles its noise. The upper box further muffles the noise and regulates the pressure.
Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!
Have an amazing project to share? Join the SHOW-AND-TELL every Wednesday night at 7:30pm ET on Google+ Hangouts.
Join us every Wednesday night at 8pm ET for Ask an Engineer!
Learn resistor values with Mho’s Resistance or get the best electronics calculator for engineers “Circuit Playground” – Adafruit’s Apps!
Maker Business — Transforming Today’s Bad Jobs into Tomorrow’s Good Jobs
Wearables — Not a loophole
Electronics — Rule of thumb: 10mils per amp.
Biohacking — Soft Artificial Human Heart #3DThursday #3DPrinting
No comments yet.
Sorry, the comment form is closed at this time.