Instructables user vspencer was inspired by Wonder Woman — especially by the design for Dr. Poison. She decided to make a replica of the character’s ceramic mask using 3D printing techniques. She started by taking a 3D scan of her face (she was fortunate enough to have access to one) and then used the scan to design the pieces of the mask. Once the three separate segments were printed, vspencer added six-seven coats of primer filler.
Here’s how she rigged the mask to stay on her face:
I ended up making 5 loops out of fishing line. This is definitely a trial and error process, but here’s the order that I did the loops in.
Fit the loop behind my left ear to hold the nose/cheek piece on my face. This is shown in the first picture.
Attach the chin and the nose piece with a loop at the corner of the mouth.
Fit a loop behind your right ear, from the chin piece. The loop should be long enough to fit underneath your chin/right jaw.
Attach the chin to the appropriate side of the jaw.
Attach the jaw to the nose/cheek piece.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
