In a previous post on setting MIDI baud-rates on the RPi I used a slight of hand (i.e. init_uart_clock etc.) to trick the RPi in setting the UART to a 31250 baud needed for MIDI. While browsing the Raspberry Pi forum I spotted this nugget of information from PhilE:
1) Enables the UART. It isn’t strictly necessary when combined with pi3-miniuart-bt
2) Reassigns the weaker UART (ttyS0) for Bluetooth and frees ttyAMA0 for our MIDI interface
3) Using an DT overlay to achieve the same UART clock settings as our init_uart_clock etc. trick
Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!
Eink, E-paper, Think Ink – Collin shares six segments pondering the unusual low-power display technology that somehow still seems a bit sci-fi – http://adafruit.com/thinkink
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.