3D Printed Case for GEMMA M0
If you’re working on a project using the Adafruit GEMMA M0, you may want a case to protect it. This simple two piece enclosure can house the PCB and a 150mAh lithium ion polymer battery.
Portable GEMMA M0
The PCB is secured to two standoffs with M2.5 (6mm long) screws. We have a nice assortment of M2.5 sized nylon screws and nuts that will work well. The case allows access to the microUSB port for powering and programming. A slide switch extension allows you to power the GEMMA M0 on and off. To keep the case (relatively) slim, an opening on the cover lets the JST connector poke through the top.
Snap Fit Cover
The cover features a “snap fit” lip that locks onto the case, making a fairly durable connection. No screws needed. The cover can be modified to completely cover the GEMMA M0 – So you have the option to remove all of the holes and openings.
Wire Access
On the sides of the case are two “slits” that allow wires to pass through. If you’re wiring sensors, NeoPixels or other components, you can fit the wires into the slits and close the cover. These slits can be removed, or add more.
The Adafruit Gemma M0 is a super small microcontroller board, with just enough built-in to create many simple projects. It may look small and cute: round, about the size of a quarter, with friendly alligator-clip sew pads. But do not be fooled! The Gemma M0 is incredibly powerful! We’ve taken the same form factor we used for the original ATtiny85-based Gemma and gave it an upgrade. The Gemma M0 has swapped out the lightweight ATtiny85 for a ATSAMD21E18 powerhouse.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Select Python on Microcontrollers Newsletter: PyCon AU 2024 Talks, New Raspberry Pi Gear Available and More! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey
