This is a DIY midi controller based off of Adafruit’s Untztrument and an Instructable called ‘Sugar Cube’ by Amanda Ghassaei. It uses a mix of components, most noticeably a 2×2 array of Adafruit Neotrellis. Uses an Arduino Leonardo for its brain. Has two Sparkfun 15mm RGB elastomer bumper buttons (achieved by cutting a 2×2 PCB in half twice). Four potentiometers, one encoder, has a 3 axis accelerometer for gesture control, 5 din midi out, toggle on/off switch, and a rechargeable 7.4 volt 2200mAh battery.
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.