Custom D&D / dice game calculator using Adafruit FEATHER m0 express and Rust
Custom D&D / dice game calculator using Adafruit FEATHER m0 express and Rust, Caleb writes –
I printed, built, and programmed a calculator for D&D and other dice based games. It rolls simple dice like ‘d20’, ‘d100’, or ‘d42’ or sets of dice like ‘4d20 + d4 + 4’
This first version of the firmware is basic, but I plan to add a ‘stats’ function to print the odds of rolling the number you rolled, a ‘test’ function to ‘prove’ that it is a fair die, and a ‘gamblers falicy mode’. Gamblers falicy mode would increase the odds of rolling a dice face that hasn’t been rolled recently, making a series of dice outcome better fit an expected distribution. This mode might take some RNG out of games like catan or machi koro.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
