This video is about compressed air cans (aka gas dusters) and why they get cold when you spray them. They cool off because the refrigerant inside (1,1-difluoroethane) is under pressure and boils off when the pressure lowers, and energy lost to the latent heat of vaporization cools the can a lot. Difluoroethane normally boils at -25°C (-13°F), but under ~6 atm (6 bar, 600 kpa) it is a liquid at room temperature. The gas also cools off slightly due to the Joule-Thompson effect of fluid expansion through a throttled valve. Difluoroethane is heavier than air and water soluble, so it is recommended to use it in a ventilated environment to clean your keyboard, etc. Also, 1,1-difluoroethane is a potent greenhouse gas. It is also known as Freon 152a, Ethylidene difluoride, Ethylidene fluoride, HFC-152a, R-152a, and DFE.
Each Saturday Morning here at Adafruit is Saturday Morning Cartoons! Be sure to check our cartoon and animated posts both nostalgic and new that inspire makers of all ages! You’ll find how-tos for young makers, approaches to learning about science and engineering, and all sorts of comic strip and animated Saturday Morning fun! Be sure to check out our Adafruit products featuring comic book art while you’re at it!
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Select Python on Microcontrollers Newsletter: PyCon AU 2024 Talks, New Raspberry Pi Gear Available and More! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey
Each Saturday Morning here at Adafruit is Saturday Morning Cartoons! Be sure to check our cartoon and animated posts both nostalgic and new that inspire makers of all ages! You’ll find how-tos for young makers, approaches to learning about science and engineering, and all sorts of comic strip and animated Saturday Morning fun! Be sure to check out our Adafruit products featuring comic book art while you’re at it!