New Products 8/14/2019 Featuring Adafruit MONSTER M4SK! @adafruit #adafruit

Screen Shot 2018 05 04 at 7 44 26 AM

We’ve got the New nEw NEW for you right here:


NEW PRODUCTS THIS WEEK


3243 00

Assembled DC Motor + Stepper FeatherWing Add-on

A Feather board without ambition is a Feather board without FeatherWings! This is the Fully assembled (with headers) DC Motor + Stepper FeatherWing which will let you use 2 x bi-polar stepper motors or 4 x brushed DC motors (or 1 stepper and 2 DC motors). Using our Feather Stacking Headers or Feather Female Headers you can connect a FeatherWing on top or bottom of your Feather board and let the board take flight!

Read more


4288 01

USB Li-Ion Power Bank with 2 x 5V Outputs @ 2.1A – 5000mAh

Here’s a hand-held-size rechargeable battery pack for your Raspberry Pi (or Metro, or anything else that uses 5V!). This pack is intended for providing a lot of power to a smartphone, tablet, etc, but we found it does a really good job of powering other miniature computers and micro-controllers. If you want even more power, we have a 10,000mAh power pack with two USB ports that can provide up to 2A!

Read more


4326 00

Micro Servo with 3-pin JST Cable – STEMMA Connector Compatible

This tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you’re used to but smaller. You can use any servo code, hardware or library to control these servos. Good for beginners who want to make stuff move without building a motor controller with feedback & gear box, especially since it will fit in small places. Of course, it’s not nearly as strong as a standard servo. Works great with the Motor Shield for Arduino, or by just wiring up with the Servo library. Comes with a few horns and hardware.

Read more


619 09

SMT RGB 5050 LED – 10 pack

These surface-mount LEDs are an easy way to add a lot of colorful dots to your project. They’re similar to the ones in our analog RGB LED strip, same size and shape. They are half a centimeter on a side, which makes them small but not so small that they are impossible to hand solder. There are three LEDs inside, red green and blue and because they are so close together, they mix very nicely, without the need for a diffuser. The LED is also insanely bright, at an eyeball-blistering 2000mcd.

Read more


4314 05

Adafruit ATECC608 Breakout Board – STEMMA QT / Qwiic

You’ve got secrets, and you want to keep them safe? Most microcontrollers are not designed to protect against snoopers, but a crypto-authentication chip can be used to lock away private keys securely. Once the private key is saved inside, it can’t be read out, all you can do is send it challenge-response queries. That means that even if someone gets hold of your hardware and can read back the firmware, they wont be able to extract the secret!

Read more


4350 01

JST SH 9-Pin Cable – 100mm long

This 9-pin cable is just about 100mm / 4″ long and fitted with JST-SH female connectors on both ends. Compared with chunkier JST-PH these are 1mm pitch instead of 2mm, but still have a nice latching feel and are easy to insert and remove.

Read more


4343 07

Adafruit MONSTER M4SK – Two Eyes are Better Than One!

Peep dis! Have you always wanted to have another pair of eyes on the back of your head? Or outfit your costume with big beautiful orbs? The MONSTER M4SK is like the Hallowing but twice as good, with two gorgeous 240×240 pixel IPS TFT displays, driven by a 120MHZ Cortex M4 processor that can pump out those pixels super fast. You’ll get the same quality display as our Raspberry Pi Eyes kit but without needing to tote around a full Linux computer

Read more


New Products 8/14/2019 Featuring Adafruit MONSTER M4SK!

Visit www.adafruit.com/new for more info.


Halloween season is here!
Halloween season is here! Check out all the posts, gift guides, and more!

Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards

Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.

Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Join over 38,000+ makers on Adafruit’s Discord channels and be part of the community! http://adafru.it/discord

CircuitPython – The easiest way to program microcontrollers – CircuitPython.org


New Products – Adafruit Industries – Makers, hackers, artists, designers and engineers! — New Products 10/30/24 Adafruit LPS28 (LPS28DFW) Pressure Sensor – STEMMA QT / Qwiic

Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: New Raspberry Pi Products, 503 CircuitPython Libraries and Much More! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi

EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey

Adafruit IoT Monthly — Halloween, WiLo, and more!

Maker Business – Adafruit Daily — First Solar’s $1.1 billion development of vertically integrated factory in the U.S.

Electronics – Adafruit Daily — Trigger happy oscilloscope?

Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at AdafruitDaily.com !



No Comments

No comments yet.

Sorry, the comment form is closed at this time.