Adafruit is celebrating Lunar New Year🐍 Wednesday 1/29/2025. In combination with MLKDay, shipping could be delayed. Please allow extra time for your order to ship!
Is it too cold, hot, humid, or dry in your home? Do you have a hunch but not sure? Any of these extremes could have an effect on your health.
Knowing the humidity inside your home is helpful. Too humid, and mold can grow as well as release allergens in the air that can cause health problems. Too dry, and other issues like throat, nose, and eye irritation may result.
Regardless of health, sometimes times it’s just fun to know the humidity and temp values of your environment!
In this guide, you’ll connect an AHT20 Temperature and Humidity sensor to an ESP32-S2 Feather. Then, load the AdafruitIO WipperSnapper firmware onto the ESP32-S2 Feather to connect your device to Adafruit IO. You’ll configure the AHT20 sensor from the WipperSnapper website to send data to Adafruit IO.
Finally, you’ll create a handy dashboard to view the temperature and humidity data.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: CircuitPython 2025 Wraps, Focus on Using Python, Open Source and More! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey
