UPDATED GUIDE: Adafruit Metro M7 1011 with AirLift #AdafruitLearningSystem #Adafruit @adafruit @BlitzCityDIY
Get ready for our fastest Metro ever – the NXP i.MX RT1011 microcontroller powers this board with a 500 MHz ARM Cortex M7 processor. There’s 4 MB of execute-in-place QSPI for firmware + disk storage and 128KB of SRAM in-chip.
The Adafruit Metro M7 1011 with AirLift guide has been updated to include CircuitPython essentials page for I2S and PWM audio. The i.MX RT1011 is a great chip for audio projects so if you are musically inclined, be sure to check out these new pages!
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7pm ET! To join, head over to YouTube and check out the show’s live chat – we’ll post the link there.