The story of the moon landing is complex. A lot has been written about the NASA engineers who worked on the Apollo missions — but a great deal of the computer design and programming work was done at MIT. Here’s more from MIT:
The computer system and its software that controlled the spacecraft — called the Apollo Guidance Computer and designed by the MIT Instrumentation Lab team under the leadership of Eldon Hall — were remarkable achievements that helped push technology forward in many ways.
…
In an age when most computers took up entire climate-controlled rooms, the compact AGC was uniquely small and lightweight. But most of its “software” was actually hard-wired: The programs were woven, with tiny donut-shaped metal “cores” strung like beads along a set of wires, with a given wire passing outside the donut to represent a zero, or through the hole for a 1. These so-called rope memories were made in the Boston suburbs at Raytheon, mostly by women who had been hired because they had experience in the weaving industry. Once made, there was no way to change individual bits within the rope, so any change to the software required weaving a whole new rope, and last-minute changes were impossible.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: Open Hardware is In, New CircuitPython and Pi 5 16GB, and much more! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey
