Tiny Raspberry Pi Cyberdeck @Raspberry_Pi #PiDay #RaspberryPi

A proper cyberdeck should look like it was kludged together in an alley in the Sprawl, under a sky the color of a television tuned to a dead channel. It should look like you can close it up, run through a crowd, jump onto a subway, and disappear into the night. It should look like anyone can make it, but only you can use it. little Raspberry Pi Cyberdeck checks all those boxes. Here’s more from Raspberry Pi Pod:

A 3S LiPo gives approx 11.1V, which is obviously too much for the Pi which wants 5-5.2V. I grabbed hold of an adjustable buck converter that takes a high power feed and converts it (steps it down) to whatever voltage you need, courtesy of a small adjustment pot at the top. Here it is with the pot turned to approximately what I needed. I later adjusted it to 5.1V to give the Pi some headroom.

You’ll see that the output of the converter goes into an Enviro+ board that is plugged into the Raspberry Pi Zero 2 W. This is where things get a little convenient. I knew I wanted some kind of sensor display for the project, and I happened to have an Enviro+ already. With a little experimentation, I found that I could take the voltage out of the converter and “shove” it into the GND and 5V pins of the Enviro+ and this would power the Pi. Marvellous. There is a cheaper board – the plain Enviro – so you might want to consider that. I also realised that I could add a control button to the Enviro+ by soldering a button to the other GND and #4 (GPIO 4), so I did that as well. The nice thing about the Enviro is that it breaks out “just enough” pins to make it easy to add things on. Those I2C (SDA/SCL) pins are just begging for more sensors – I don’t have any more room in the case, though!

See more!


3055 06Each Friday is PiDay here at Adafruit! Be sure to check out our posts, tutorials and new Raspberry Pi related products. Adafruit has the largest and best selection of Raspberry Pi accessories and all the code & tutorials to get you up and running in no time!


Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!

Join us every Wednesday night at 8pm ET for Ask an Engineer!

Join over 38,000+ makers on Adafruit’s Discord channels and be part of the community! http://adafru.it/discord

CircuitPython – The easiest way to program microcontrollers – CircuitPython.org


New Products – Adafruit Industries – Makers, hackers, artists, designers and engineers! — New Products 11/15/2024 Featuring Adafruit bq25185 USB / DC / Solar Charger with 3.3V Buck Board! (Video)

Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: A New Arduino MicroPython Package Manager, How-Tos and Much More! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi

EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey

Adafruit IoT Monthly — The 2024 Recap Issue!

Maker Business – Adafruit Daily — Apple to build another chip at TSMC Arizona

Electronics – Adafruit Daily — SMT Tip – Stop moving around!

Get the only spam-free daily newsletter about wearables, running a "maker business", electronic tips and more! Subscribe at AdafruitDaily.com !


No Comments

No comments yet.

Sorry, the comment form is closed at this time.