Eliminating serial RX/TX swap woes #SMD #PCB @BrainCodec
It’s something that may designers have run across. In designing a serial interface, the transmit (TX) and receive (RX) lines are switched, leading to no communication. When this gets to the printed circuit board (PCB) level, it can cause near impossible rework and then later respinning a new design to correct the issue.
Fixing a TX/RX swap on a circuit board can be painful. Photo credit @arturo182 on X.
@BrainCodec on X (formerly Twitter) shows an interesting PCB design accommodating reversal of RX and TX without changing PCB traces. Two zero ohm (0R) resistors are mounted horizontally or vertically to make the desired connections. Changes are as easy as a bit of hot air component removal and resoldering.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: Diving into the Raspberry Pi RP2350, Python Survey Results and more! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey
