What Runs Doom? An Adafruit 2.8″ TFT Touch Shield and an ESP32 #DailyDoom #Doommas
In December, Adafruit is showcasing hardware that runs the vintage game Doom, with a special emphasis on things you would not expect could run the popular game.
Where can’t you play Doom? A fun entry into the logs of Doom is this build from Naveen on Hackster.io. They use an Arduino Nano ESP32 to run Doom. Played with a joystick on the Adafruit 2.8″ TFT Touch Shield.
The original DOOM game required at least 4MB of RAM and 20MB of disk space, which are much larger than the typical microcontroller specifications. To port the game, some compression and optimization techniques are needed to fit the game data and code into the microcontroller’s flash memory and RAM and some modifications and adaptations are needed to make the game engine run on a different platform and architecture, such as an ESP32 or RP2040 chip. However, these changes may introduce some errors or differences in the game behavior and performance, which may affect the gameplay experience.
Lately, there have been several efforts to make the game compatible with low-powered microcontrollers. For our project, we’ve opted to use Retro-Go, an open-source firmware that allows retro games to be played on ESP32-based MCUs. While this firmware doesn’t support Arduino Nano ESP32 directly, its flexibility and configurability make it possible to be ported to other ESP32-based MCUs.
Adafruit publishes a wide range of writing and video content, including interviews and reporting on the maker market and the wider technology world. Our standards page is intended as a guide to best practices that Adafruit uses, as well as an outline of the ethical standards Adafruit aspires to. While Adafruit is not an independent journalistic institution, Adafruit strives to be a fair, informative, and positive voice within the community – check it out here: adafruit.com/editorialstandards
Stop breadboarding and soldering – start making immediately! Adafruit’s Circuit Playground is jam-packed with LEDs, sensors, buttons, alligator clip pads and more. Build projects with Circuit Playground in a few minutes with the drag-and-drop MakeCode programming site, learn computer science using the CS Discoveries class on code.org, jump into CircuitPython to learn Python and hardware together, TinyGO, or even use the Arduino IDE. Circuit Playground Express is the newest and best Circuit Playground board, with support for CircuitPython, MakeCode, and Arduino. It has a powerful processor, 10 NeoPixels, mini speaker, InfraRed receive and transmit, two buttons, a switch, 14 alligator clip pads, and lots of sensors: capacitive touch, IR proximity, temperature, light, motion and sound. A whole wide world of electronics and coding is waiting for you, and it fits in the palm of your hand.
Have an amazing project to share? The Electronics Show and Tell is every Wednesday at 7:30pm ET! To join, head over to YouTube and check out the show’s live chat and our Discord!
Python for Microcontrollers – Adafruit Daily — Python on Microcontrollers Newsletter: Open Hardware is In, New CircuitPython and Pi 5 16GB, and much more! #CircuitPython #Python #micropython @ThePSF @Raspberry_Pi
EYE on NPI – Adafruit Daily — EYE on NPI Maxim’s Himalaya uSLIC Step-Down Power Module #EyeOnNPI @maximintegrated @digikey
